|
C05 | DECT VoIP with ADSL Router |
AW-639 |
ADSL Protocols/Interfaces |
Compliant with ADSL standards |
Full-rate ANSI T1.413 Issue 2 and ITU G.dmt (G.992.1) |
standards |
Splitterless ITU G.lite (G.992.2)specification |
ADSL over POTS (Annex A) // ISDN(Annex B ETSI) // |
ISDN (Annex B U-R2) |
DMT modulation and demodulation |
Full-rate adaptive modem |
Maximum downstream rate of 8 Mbps Maximum |
upstream rate of 1 Mbps |
Tone detection for low power mode |
Supports splitterless ADSL implementation Supports |
Dying Gasp |
ATM protocols (firmware dependent) |
WAN mode support: PPP over ATM (RFC 2364) and |
PPP over Ethernet (RFC 2516) |
LAN mode support: bridged/routed Ethernet over |
ATM (RFC 1483) and Classical IP over ATM(RFC 1577) |
ATM Forum UNI 3.1/4.0 PVC |
Up to 8 VCs (Virtual Circuits) |
Firmware upgrade via FTP |
Customizable Web pages |
WAN and LAN side connection statistics |
Configuration of static routes and Routing table |
Configuration of NAT/NAPT |
Password protected access |
ATM SAR (Segmentation and Reassembly) ATM AAL5 |
(Adaption Layer type 5) |
OAM F4/F5 // Bridge Mode (firmware dependent) |
Ethernet to ADSL self-learning ransparent Bridging (IEEE 802.1D) |
Supports up to 128 MAC learning dresses |
Router Mode (firmware dependent) |
IP routing–RIPv2 (backward compatible with RIPv1) |
Static routing |
DHCP (Dynamic Host Configuration Protocol)Server and Client |
NAPT (Network Address and Port Translation) |
NAT (Network Address Translation) |
ICMP (Internet Control Message Protocol) |
Simultaneous USB and Ethernet operation(Option) |
IGMP (Internet Group Management Protocol) |
Security (depends on firmware) |
User authentication for PPP |
PAP (Password Authentication Protocol) |
CHAP (Challenge Authentication Protocol) |
Password protected system management |
Vendor specific descriptors |
HTTP Web-based management (firmware dependent) |
Selection of Bridge or Router Mode |
PPP user ID and password |
Configuration of VCs (Virtual Circuits) |
Auto configuration easy setup program,easy for user’s configuration |
(Windows base) |
|
Single RJ11port supports legacy (analog) touch-tone telephones |
Radvision Sip stack version 3.0.4.0 |
Digest Authentication MD5 |
Record-Route Headers |
uVoice codecs: G.729A //G.711 A-Law //G.711 u-Law |
uDual-tone multi-frequency (DTMF): |
ü DTMF tone detection and generation |
ü Mid-Call DTMF for IVR support // RFC 2833 AVT tones |
ü Configurable for two sets of frequencies and single set of |
ü on/off cadence (US,UK) |
uLine-echo cancellation: |
ü G.165, G.168 compliant // Echo canceller for each port |
ü 8 to128 msec configurable echo length // Nonlinear echo suppression |
ü Convergence time = 250 ms // ERLE = 10 to 20 dB |
Support 4 Ports Ethernet Switch Interface (10/100Mbps) which compliant with IEEE 802.3x standards |
10/100 Mbps auto selection |
Ethernet ports support Automatic MDI/MDI-X configuration transceiver |
USB host interface(Option) |
Frequency : 1880 ~ 1900 MHZ |
GAP compatible |
Can register up to 5 handsets |
Range : Outdoor up to 300Meters; Indoor up to 50 Meters |
One hardware button for call and register handsets function |